by cecile | 22:37

What You Should Keep in Mind Before You Buy that Data Center Lift System

The installation of such heavy IT equipment into the rack poses a big risk of injury to workers when such is done manually. You would make the right decision when you are going to use the data center lifts. Before buying a server lifter, there are essential things that you must consider first. A few of the characteristics which may be touted as benefits could have severe consequences when you don’t know what you should be looking for.

You should be looking for a device which is really built for the data centers. There are two aspects that you should consider regarding this matter. One would be to pertain to such suitability of the server lifting device to such data center environment and you should know that the other is on the potential for those code violations.

A common error would be to buy a server lift device made for the general purpose or the one that is used for warehouse applications. Often, they aren’t easy to maneuver in the data center aisles and they also have insufficient braking systems and don’t have such mechanism to extend into the rack for an easy and safe installation.
Why Servers Aren’t As Bad As You Think

When the lift device would use hydraulic fluids or an oil in any of the mechanisms, then it can be a violation of such data center policy. The policies and codes should protect the people and the equipment and should be followed strictly.
News For This Month: Lifts

What you must also make sure is that the data center lifting system should be able to fully insert equipment into those racks. A lot of such general purpose lift systems would lift the equipment to the height desired but this can’t hold such in place in the rack when this is actually fastened in position. Installation of such heavy equipment with a gap below should have several technicians for holding the device while one would fasten such in place, this wastes time and has some safety risks.

The lift system which is able to hold the equipment in place in the rack while this is being fastened is the only method to allow a single technician to install such heavy equipment without the help of those assistants.

You should also be choosing a lift which is able to stay solid and level while carrying a maximum load. The lift device should be able to accept those weight of servers, the batteries, switches and also the supplies which you are using today. It is much better that you select that unit that has a larger capacity than what you presently need to be able to accommodate the heavier equipment that you will need in the future.

  COMMENTS OFF